6
Rear bracket
a. Ensure that the adjustment screws on the mounting rail are loose but not detached so that the
mounting rail can extend or contract as needed.
b. Place the mounting rail inside the cabinet, and extend the mounting rail until the flanges on
the mounting rail touch the inside of the cabinet.
c. Insert two M5 screws through the front of the cabinet, and screw them into the second and
fourth threaded holes from the top captured nut in the mounting rail.
1
M5 screws
d. Insert two M5 screws through the rear of the cabinet, and screw them into the captured nuts in
the rear flange in the mounting rail.
e. Counting up from the bottom of the mounting rail, place the bottom screw of the rear bracket
in the 8th hole of the cabinet so that the top of the rear bracket is in the 11th hole. The
distance between the two holes should be 1U or 4.45 cm (1.75 in).
f. Tighten the adjustment screws on the mounting rail.
g. Repeat these steps to install the second mounting rail.
h. Insert one M5 screw through the front of the mounting rail. This screw attaches the controller-
drive tray to the cabinet.
Step 4 - Installing the controller-drive tray | 47
Содержание E2760
Страница 2: ......
