NEC MC2200, Руководство пользователя

Страница: 111 / 142

Problem Solving 5-15
Table 5-2. BIOS Messages
MESSAGE DESCRIPTION
Nnnn Cache SRAM Passed Where nnnn is the amount of system cache in kilobytes successfully
tested.
Diskette drive A error
or
Diskette drive B error Diskette Drive is present but fails the BIOS POST diskette tests. Check
to see that the drive is defined with the proper diskette type in Setup
and that the diskette drive is correctly attached.
Entering SETUP ...
The Setup program is starting.
Extended RAM Failed at offset: nnnn* Extended memory is not working or is not properly configured at offset
nnnn.
nnnn Extended RAM passed
Where nnnn is the amount of RAM in kilobytes successfully tested.
Failing Bits: nnnn* The hex number nnnn is a map of the bits at the RAM address (in
System, Extended, or Shadow memory) which failed the memory test.
Each 1 (one) in the map indicates a failed bit.
Fixed Disk 0 Failure
or
Fixed Disk 1 Failure
or
Fixed Disk Controller Failure*
Fixed disk is not working or not properly configured. Check to see if the
fixed disk is attached properly. Run Setup to be sure the fixed disk type
is correctly identified.
Incorrect Drive A type - run SETUP
or
Incorrect Drive B type - run SETUP
Type of floppy drive is not correctly identified in Setup.
Invalid NVRAM media type* Problem with NVRAM (CMOS) access.
Keyboard controller error* The keyboard controller test failed. You may have to replace the
keyboard or controller.
Keyboard error nn
The keyboard is not working. BIOS discovered a stuck key and displays
the scan code
nn for the stuck key.
Keyboard locked - Unlock key switch
Unlock the system to proceed.
Monitor type does not match CMOS -
Run SETUP
Monitor type is not correctly identified in Setup.
Operating system not found
The operating system cannot be located on either drive A: or drive C:.
Enter Setup and see if the fixed disk and floppy are properly identified.
Parity Check 1 nnnn*
or
Parity Check 2 nnnn* A parity error was found in the system bus (Parity Check 1) or the I/O
bus (Parity Check 2). BIOS attempts to locate and display the address
on the screen. If it cannot locate the address, it displays ????.
Press <F1> to resume, <F2> to Setup
Displayed after any recoverable error message.
Press <F2> to enter SETUP
Optional message displayed during POST. Can be turned off in Setup.
Previous boot incomplete - Default
configuration used
Previous POST did not successfully complete. POST loads default
values and offers to run Setup. If the failure was caused by incorrect
values and they are not corrected, the next boot will likely fail. On
systems with control of wait states, improper Setup settings can also
terminate POST and cause this error on the next boot. Run Setup and
verify that the wait-state configuration is correct. This error is cleared
the next time the system is booted.
Real time clock error* Real time clock fails BIOS test. May require board repair.
Shadow Ram Failed at offset: nnnn* Shadow RAM failed at offset nnnn of the 64K block at which the error
was detected.
nnnn Shadow RAM Passed Where nnnn is the amount of shadow RAM in kilobytes successfully
tested.
System battery is dead - Replace and
run SETUP
The CMOS clock battery indicator shows the battery is dead. Replace
the battery and run Setup to reconfigure the system.
System BIOS shadowed The system BIOS is copied to shadow RAM.
System cache error - Cache disabled* The RAM cache failed the BIOS test and BIOS has disabled the cache.