1. Setup Procedure
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
25
Chapter 1 Installing Operating System
1.6
Setting HBA configuration by using Qlogic
Setting HBA configuration by using Qlogic. Setting is needed to HBA installed into each CPU/IO module 0 and
1.
Important Before setting the HBA configuration by using QLogic BIOS, it is required to complete
the storage settings such as creating a logical disk.
1. Connect power cords in the following order to start the system from CPU/IO module
0
.
(1) Connect a power cord to AC inlet
A
.
(2) Connect a power cord to AC inlet
B
.
(3) Make sure that POWER LED on each module is blinking green.
Note
Wait at least 15 seconds after step (1), and then perform step (2).
If you disconnect a power cord, wait for at least 30 seconds before connecting it again.
Tips
See
Chapter 1 (1.2 Preparations for Setup)
for AC inlet connector.
Important Make sure that the PRIMARY LED on CPU/IO module 0 is lit.
2. Press the POWER switch that is located on the front side of the server.
2-1
In the QLogic prompt window which appears during POST, press
Ctrl+Q
or
A
lt+
Q
to launch
QLogic
Fast! UTIL.
Note
If QLogic prompt is not indicates, check the “PCIx Slot Option ROM” and “Boot Mode”
setting. Refer to step 9 and step 10 in
“1.4 Enabling Fibre Channel card”
.