9. Offline Tools
Express5800/E120f-M Maintenance Guide
53
Chapter 1 Maintenance
9.2
Features of Offline Tools
Offline Tools offer the following features.
Note
If you start the Offline Tools while RDX is connected to the server, disable RDX
before starting the offline tools by setting RDX to hibernate mode.
•
Off-line Maintenance Utility
The Off-line Maintenance Utility is started when
Maintenance Utility
is selected. The Off-line Maintenance
Utility is used for preventive maintenance and failure analysis for this product. When you are unable to
start NEC ESMPRO due to a failure, the Off-line Maintenance Utility can be used to check the cause of the
failure.
Note
The Off-line Maintenance Utility is intended for mainenance personnel. Consult
with your service representative if a trouble that requires Off-line Maintenance
Utility occurs.
After starting up the Off-line Maintenance Utility, the following features are available to run.
−
IPMI Information Viewer
Displays System Event Log (SEL), Sensor Data Record (SDR), and Field Replaceable Unit (FRU) in
Intelligent Platform Management Interface (IPMI) and also back up such logs.
Using this feature, system errors and events can be investigated to locate the parts to be replaced.
You can also clear the SEL area, and specify the operation when the SEL area becomes full.
−
System Information Viewer
Displays information on processor (CPU), BIOS.
Also output the information to a text file.
−
System Information Management
Set the information specific to your server (Product information, Chassis information)
•
Server Configuration Utility
−
Use this utility to cofigure the alert notification feature by EXPRESSSCOPE Engine 3 and use the remote
management feature through management PC.
