NC1600C
3. Projector Adjustment and Connection
D-51
3.6.6
Adjusting the pan angle
Adjust the pan angle so that the heights on
the right and left of the image become
equivalent.
[1]
Loosen the two pan angle
adjusting screws (f) and
(r).
[2]
Tighten pan angle
adjusting screw (f) to
adjust in the E-direction,
tighten pan angle adjusting
screw (r) to adjust in the
F-direction.
[3]
After adjusting, tighten the
pan angle adjusting screw
on the side opposite the
one adjusted in step <2>
to fasten.
3.6.7
Checking the Adjustment Results
This completes the adjustment of the anamorphic lens. Check that the projected image is
substantially at the center of the anamorphic lens and that four corners of the projected
image are not eliminated by the anamorphic lens (check whether the image has a notch or
not).
If the image is not fully given, repeat the steps in “3.6 Adjusting the anamorphic lens”
(Page D-46).
Direct the
anamorphic
lens to the right
Pan angle adjusting
screw (f)
Pan angle
adjusting
screw (r)
Direct the
anamorphic
lens to the left
