NC1600C
2. Setting Up Your Projector
D-33
[3]
Mount the lens holder onto
which the anamo-lens is
mounted to the slide unit.
<1> Turn the lens holder’s knob hole to the
position of the roll angle fixing knobs,
insert, then turn clockwise.
<2> Tighten the two roll angle fixing knobs
and tighten the lens holder.
<3> Remove the lens cap.
[4]
Insert the power supply/
control connector into the
projector side connector.
This completes the mounting of the anamo-lens in case of the stand NC-AT02. Adjust the
anamo-lens after completion of the primary lens adjustment. For details, refer to “3.6
Adjusting the anamorphic lens” (Page D-46).
Roll angle
fixing
knobs
Power supply/
Control connector
