NC1600C
3. Projector Adjustment and Connection
D-40
3.2
Turning your projector on
Preparation: Supply AC power to the projector head.
Note
•
While your projector is on, be sure to have the lens cap removed from the lens.
Otherwise, the lens cap may get deformed due to a heat buildup.
•
In the following instances, the power to your projector cannot be turned on even if you
press the POWER button.
- When the inside temperature is abnormally high. The protective function prevents power
from turning on. Wait some time (until the projector inside cools down) and then turn
on the power.
- When the STATUS indicator is blinking without the lamp lighting up after power-on. Your
projector may be in trouble. Check the error display on the LCD screen and contact your
dealer/distributor for instructions.
•
Note that the image may sometimes flicker until the lamp has stabilized (3 to 5 minutes)
after power-on. This is due to the characteristics of the lamp and is not trouble of your
projector.
[1]
Remove the lens cap.
[2]
Turn the main power switch on the
front of your projector head to on.
A buzzer will ring on the projector. The POWER
indicator and rear STATUS indicator light up orange
(standby state)
[3]
Press the POWER button on the
control panel of your projector
three seconds or longer.
Your projector is turn on, and the screen glows light
about 30 seconds later. The POWER indicator of the
projector lights up green.
When controlling with the remote control, press the
POWER ON button three seconds or longer.
