NC1600C
3. Projector Adjustment and Connection
D-50
3.6.5
Adjusting the tilt angle
Adjust the tilt angle so that the distortions
at the top and the bottom of the image
become equivalent.
Note
•
When you adjust the tilt angle, pay attention so that the anamorphic lens does not contact
the primary lens. If the anamorphic lens is touch the primary lens, repeat the steps in
“3.6.1 Z-direction adjustment” (Page D-46).
[1]
Loosen the two tilt angle
fixing knobs.
[2]
Loosen the tilt angle
adjusting screw to adjust in
the C-direction, tighten it
to adjust in the D-direction.
[3]
After adjusting, tighten the
two tilt angle fixing knobs
to fasten.
Set the
anamorphic lens
upward.
Set the
anamorphic lens
downward.
Tilt angle fixing knobs
Tilt angle
adjusting screw
