mru SWG100 CEM, Руководство пользователя

Страница: 64 / 155

MRU GmbH SWG 100 User Manual
Page 64 of 155
•
List of the installed alarmoutput ports (1): At this list the operator can select, which
alarm output should be configured.
•
Details (2): Here the operator can open the configuration screen for the selected alarm
output. To open the details-menu, push F1 or OK .
•
Auto configuration (3): If the operator pushes this key ( F2 ) the output pins would be
configured by default values.
•
Test (4): The test-menu is for testing the alarm outputs. To open the test-menu, push
F3 or OK .
+
The settings for an alarm- output can be changed in the “Alarm output details” menu. See the
screenshot below.
o
Section (1): Shows the operator, which alarm-
output will be change.
o
Sample point (2): The operator can select the
sample point. This means, that the alarm-output
signal from the choose sample point will be
transmitted to the process control system.
o
Meas. Item (3): At this point the operator selects
the measurement item, which should be
monitored. At the chart below, the typical
measurements items are counted. Basically, all
measurement-channels, which can be measured,
can be selected at this point.
o
Meas. Unit (4): This point shows, which unit the
transmit signal have. This point cannot be
changed.
o
Threshold (5): Here the threshold will be
determined.
o
Alarm of value is (6): The operator can determine,
if the alarm will be triggered above the determine
threshold, or below the threshold.
o
Return (7): Leave the menu. Alternate push F1.
2. Example: Alarm output to control room
Starting position:
For navigation
and selection
1
2
3
4
5
6
7