MRC MIA-LA, Руководство по эксплуатации

Страница: 58 / 92

Ultrasonic milkanalyser
Operation manual 58/92
By which the device passes in a mode of measuring high fat samples.
This calibration mode is active till the power supply of the device is switched
off i.e. it has to be always set if the device will be calibrated for high fat
measurement.
8.7. Working with embedded accumulator (option).
On customers’ request accumulator could be embedded in the milk analyser.
In this way it could work independently on the electrical network. In this case
the Power switch on the rear panel of the analyser serves for close / open the
electric circuit of the outer power supply. After closing the circuit, in order to
start the analyser, the operator has to press the Start button on the front
panel of the analyser.
Switching off the analyser could be done on one of the following ways:
Through the analyser
– by switching the Power button on the rear panel of
the analyser.
Through the software
– by using the option Shut Down from the Calibration
and Working mode menus.
After pressing and holding pressed the button Enter (when choosing
calibration), the following is displayed:
Milk selector
Cal1
– Cow
Cal2
– Sheep
Cal3
– UHT
-----------------------------
Cleaning
Final clean
Shut Down
By choosing the option Shut Down the operator may switch off the power
supply of the analysers.
In case that the external power supply from the electrical network, the
analyzer automatically starts working with power supply from the battery.
Possible working modes with battery:
1. The analyser is powered by the battery, works normally, the display shows
the following message
Battery Powered