MPE DP SERIES II, Руководство по эксплуатации и обслуживанию

Страница: 87 / 145

OUTPUT:PROTECTION:CLEAR
Query Syntax: none
Related Commands: *RST, *RCL, *SAV
4.3.6 Abort Subsystem
This subsystem cancels any trigger actions presently in process. Any pending trigger levels are
reset to their immediate values. ABOR also resets the WTG bit in the Operation Register. If
initiate continuous is enabled (INIT:CONT ON), the trigger subsystem immediately re-initiates
itself after ABORt, thereby setting WTG. ABOR is executed at power turn on and upon execution
of *RCL or *RST.
Command Syntax: ABORt <>
Examples: ABOR
Query Syntax: None
Related Commands: INIT, TRIG, *RCL, *RST
4.3.7 Trigger Subsystem
This subsystem controls remote triggering of the power supply. When the trigger subsystem is
enabled, a TRIG command generates a trigger signal. The trigger signal will then initiate a
pending level change as specified by CURR[:LEV]:TRIG or VOLT[:LEV]:TRIG. Afterwards, the
Operation Register will be cleared. If INIT:CONT is on, the trigger subsystem is immediately re-
enabled for subsequent triggers. As soon as it is cleared, the WTG bit is again set to 1.
Command Syntax: TRIGger[:IMMediate] <>
Examples: TRIG
TRIGGER:IMMEDIATE
Query Syntax: None
Related Commands: ABOR, CURR:TRIG, INIT, *TRG, VOLT:TRIG
4.3.8 Initiate Subsystem
This subsystem enables the trigger system. When the initiate subsystem is enabled, a TRIG
command allows specified triggering action to occur. If the initiate subsystem is not enabled, all
trigger commands are ignored. If INIT:CONT is OFF, then INIT enables the trigger subsystem
74