MPE DP SERIES II, Руководство по эксплуатации и обслуживанию

Страница: 11 / 145

4.3.9.3 CAL:POT 76
4.3.9.4 CAL:SCAL:VOLT 76
4.3.9.5 CAL:SCAL:CURR 77
4.3.9.6 CAL:SCAL:INP 77
4.3.9.7 CAL:DEF 77
4.3.9.8 CAL:STOP 78
4.3.10 Configure Subsystem 78
4.3.10.1 REM:SENS 78
4.3.10.2 CONT:INT 79
4.3.10.3 CONT:EXT 79
4.3.10.4 INTE 79
4.3.10.5 CONF:SETPT 80
4.3.11 GPIB Communications Subsystem 80
4.3.11.1 GPIB:VERS? (Optional GPIB only) 80
4.3.11.2 GPIB:ADDR (Optional GPIB only) 81
4.3.12 Ethernet Communications Subsystem 81
4.3.12.1 NET:VERS? (Optional Ethernet only) 81
4.3.12.2 NET:MAC? (Optional Ethernet only) 81
4.3.12.3 NET:SER? (Optional Ethernet only) 82
4.3.12.4 NET:ADDR (Optional Ethernet only) 82
4.3.12.5 NET:GATE (Optional Ethernet only) 83
4.3.12.6 NET:SUBN (Optional Ethernet only) 83
4.3.12.7 NET:PORT (Optional Ethernet only) 83
4.3.12.8 NET:HOST? (Optional Ethernet only) 84
4.3.12.9 NET:DHCP (Optional Ethernet only) 84
4.3.13 Recall Subsystem (DPD Series only) 85
4.3.14 Modulation Subsystem (DPD Series only) 85
4.3.14.1 MOD:TYPE:SEL 85
4.3.14.3 MOD:SAVE 87
4.3.14.4 MOD:TABL:LOAD 88
4.3.15 SCPI Data Formats 88
4.4 IEEE-488 Event Processing 88
4.5 IEEE-488 Standard Commands 89
4.5.1 Clear 89
4.5.2 Read Event Status Register 89
4.5.3 Read and Set Event Status Enable Register 91
4.5.4 Read Status Byte Register 91
4.5.5 Read and Set Service Request Enable Register 92
4.5.6 Read Model Number, Part Number, and Serial Number 93
4.5.7 Save 93
4.5.8 Recall 94
4.5.9 Reset 94
4.6 Error Messages 95
4.7 Restricted Command Set 95
vii