MOTU micro express-USB, Руководство пользователя

Страница: 115 / 156

U S I N G T H E F R O N T P A N E L L C D
113
You may need to experiment to adjust these values.
See “Checking the Click-to-MIDI settings” on
page 113.
7
Turn the CURSOR knob one click to the right to
go to the CLICK TO MIDI output assignment
window.
8
Use the CURSOR and VALUE knobs to set the
output channel, MIDI note number, and input
cable assignment.
☛
Note: the click-to-MIDI output assignment
cannot be assigned directly to an output cable.
Instead, it must be assigned to an input cable with
which it gets merged.
Checking the Click-to-MIDI settings
Use the WINDOW knob to go to the PEDALS
window. Play the audio click. Watch the display.
You should see the bar indicator flash for every
click. You can also observe the green MIDI OUT
LED’s on the front panel to see if they flash in sync
with the click as well. If they miss a beat, or if they
seem to flicker or stutter with a doubled attack, try
adjusting the threshold and decay.
PROGRAMMING KNOBS TO SEND DATA
Use the WINDOW knob to go to the KNOB
window.
Make the KNOB settings with the SELECT,
CURSOR and VALUE knobs as follows:
1
Turn the CURSOR knob one click to the right to
go to the KNOB START/STEP SIZE window.
2
Use the SELECT and VALUE knobs to set the
start value and step size for each knob.
The start value is the value that the knob gets set to
when you first call up the base setup or modifier
that stores the knob settings. The step size
determines the value change of the controller or
patch change messages every time you turn the
knob one click. Normally, the value will change by
one. You could, however, get a more dramatic
change with less turning of the knob by making
this value five, for example. Then the knob will
generate values of 0, 5, 10, 15, 20, 25, etc. on each
click as you turn it.
3 Turn the CURSOR knob one click to the right to
go to the KNOB RANGE window.
4
Use the SELECT, CURSOR and VALUE knobs
to set the range for each knob.
These values determine the lowest and highest
value that the knob can generate.
5
Turn the CURSOR knob one click to the right to
go to the KNOB output assignment window.
C L I C K T O M I D I
D
I N 1 C H 1 n 6 1
K N O B S
1 2 7 1 2 7 1 2 7 1 2 7
E
K N O B S T A R T 1 2 7
D
A > S T E P 1
E
K N O B R A N G E
D
S E L A > 0 - 1 2 7
E
K N O B A I N
D
# 1 > 1 B 2 7 X X
!USB Interfaces Manual Book Page 113 Tuesday, October 10, 2000 12:43 PM