MOTU micro express-USB, Руководство пользователя

Страница: 113 / 156

U S I N G T H E F R O N T P A N E L L C D
111
■
Momentary (for a foot switch)
■
LRC (available for Pedal B only)
■
Off
If you are not sure whether your pedal is a KORG
type or Roland type, choose one and then see
“Verifying that the pedal is working” on page 112.
For the Alesis LRC, use the SELECT knob to
choose PEDAL B and use the VALUE knob to
choose LRC.
Pedal Polarity
Use the SELECT knob to choose between pedal A
and pedal B. Use the VALUE knob to choose
between positive (+) and negative (-) polarity.
Negative polarity reverses the direction of the
pedal, so that if it normally goes up when you press
down, negative polarity will make it go down (and
vice versa). If you aren’t sure which to choose, use
positive and then check it by going to “Verifying
that the pedal is working” on page 112.
Pedal Range
Use the SELECT knob to choose between pedal A
and pedal B. Use the CURSOR knob to select the
low and high end of the range. Use the VALUE
knob to set the numbers. This is the minimum and
maximum value that the pedal will generate.
PEDAL OUTPUT ASSIGNMENT
To select the pedal, use the CURSOR knob to go
back to the previous window and use the SELECT
knob to select the pedal. In this window, use the
SELECT knob to choose among four possible
output assignments. Use the CURSOR knob to
switch between the four output assignment
parameters (input cable, data byte, channel byte,
and controller/note number).
☛
Note: pedal output cannot be assigned
directly to an output cable. Instead, it must be
assigned to an input cable with which it gets
merged.
P E D A L T Y P E
D
P E D A L A > C L I C K
E
P E D A L T Y P E
D
P E D A L B > L R C
E
P E D A L P O L A R I T Y
D
P E D A L A > +
E
P E D A L R A N G E
D
S E L A > 0 - 1 2 7
E
P E D A L A C M D
D
# 1 > 1 B 0 7 X X
This identifies the
currently selected
output parameter
below.
Select the pedal in
the previous window. Use the CURSOR knob
to select these four
output parameters.
input
cable Data
type
byte
(in
MIDI
channel
byte
(in hex)
Controller
or
note
number
Use the SELECT
knob to switch
between the four
possible output
assignments
!USB Interfaces Manual Book Page 111 Tuesday, October 10, 2000 12:43 PM