Motion Control Engineering Nidec iControl, Руководство пользователя, Страница: 84 / 453

3-9
Exit Construction Mode
iControl AC
3
Exit Construction Mode
Perform the following checks before exiting construction mode:
1. On the iBox, verify that the green CARTOP LED is lighted indicating that the controller
is communicating with the cartop processor board. If not, check the CARTOP LINK wir-
ing. The terminals must be connected as follows: (iBox TX+ and TX- terminals to CTP
board RX+ and RX- terminals. iBox RX+ and RX- terminals to CTP board TX+ and TX-
terminals.)
2. In iView, display the Operational Status tab. Run the car and monitor the Position - Log-
ical and Position - Cartop values. Verify that values increase when the car is moving in
the up direction. The value(s) could be negative, in which case they must become less
negative when the car moves in the up direction.
3. As the car moves, monitor the Leveling Sensor indicators on the Operational Status tab.
Verify that the sequence is correct. When the car is traveling in the up direction, the
sequence should be, Front/Rear Up leveling marker, followed by Front/Rear Door zone,
followed by Front/Rear Down leveling marker.
To exit construction mode:
1. From the iView Write privilege menu, select Acquire. The iBox LCD will display a mes-
sage requesting write privileges for iView.
2. On the iBox, press the “Yes” (1) softkey to assign write privileges to iView.
3. Open the Safety screen.
4. Click the Construction Mode check box (remove check mark).
5. Click the Send button.
6. You must then re-learn the Safety Configuration.
Please refer to “Learning the Safety
Configuration” on page 2-19 .
Running on Machine Room Inspection
When ready to run the elevator on Inspection:
1. Verify iBox Computer, Safety A, Safety B, and Cartop status LEDs are lighted solidly
green.
2. Move the Inspection switch to the INSP position.
3. Move the Controller Stop switch to the RUN position.
Within 5 seconds, the Safety OK and Doors Locked LEDs should be on and the Fault LED
should be off.
4. Verify Car Door Bypass and Hall Door Bypass switches are set to the OFF position.
5. Verify that the car is in Machine Room Inspection on the iBox or in iView. If the car is in
another inspection mode (i.e., Cartop Inspection, In-car Inspection, or Hoistway
Access), turn them off. The INCT, INA, and INCP inputs on the left edge of the iBox
should be high (110VDC).
6. Press and hold the Enable button, then press the Up or Down button to run the car. Run
the car away from the terminal landing.
7. On the iBox or on the iView Hoistway screen, verify car speed (Actual Speed). Use the
iBox or iView Actual Speed as the speed reference.