Motion Control Engineering Nidec iControl, Руководство пользователя, Страница: 228 / 453

6-43
iControl Messages
iControl AC
6
Hall Call Service Disabled
Description: Car is rejecting hall calls (iBox IN GROUP indicator is Off and the Hall call reject status LED on
the iView Diagnostics > Diagnostic Outputs > Car Operation tab is On) either because of current mode of
operation (Inspection, Test, Independent service, Capture) or because of a fault condition.
Car Reaction: Hall calls are rejected.
Troubleshooting:
1. Verify car is not on a mode of operation in which hall calls are not accepted.
2. Check iView Faults text box and Event Log for faults that would cause car to reject hall calls.
3. If car is not responding to hall calls, but neither 1 or 2 apply, problem could be due to loss of communi-
cation with dispatcher, security settings, heavy load status or hall call system malfunction.
Hall Call Service Enabled (see Hall Call Service Disabled)
Description: Car is accepting hall calls (iBox IN GROUP indicator is On). See also, Hall Call Service Disabled.
Heat Detectors Recall Activated, HEAT DETECTORS RECALL
Description: A heat detector input has been activated.
Car Reaction: Car parked at a floor will open doors and shut down. Car in motion proceeds in current direc-
tion to next available floor where heat detector is not tripped. If all heat detectors in current direction are
tripped, car reverses direction and proceeds to first floor where heat detector is not tripped. If again all heat
detectors are tripped, car proceeds to main fire recall floor unless car is also on Fire Service, in which case
car proceeds to fire recall floor. Once stopped at a floor, car automatically opens doors and shuts down. Then,
if machine room or hoistway heat detectors are active, a signal is provided to disconnect main power line and
activate the sprinklers where available.
Heat Detectors Recall Complete
Description: Indicates car has completed Heat Detectors Recall operation (at a floor and doors fully open).
Car Reaction: Shut down until all heat detector inputs deactivated (Heat Detectors Recall Deactivated).
Heat Detectors Recall Deactivated
Description: All heat detector inputs are deactivated
Car Reaction: The car is allowed to run.
Heat Sensor Fault ‘n’ (n = 2 to 4)
Description: Not currently used.
Hoistway Access Disabled, HA INSP. DISABLED
Description: Hoistway access inspection operation has been disabled.
Car Reaction: The car cannot be run on hoistway access inspection operation.
Troubleshooting:
1. Check for any car status that might prevent hoistway access inspection operation, e.g. earthquake.
2. Check for the Stuck Inspection Input Fault.
3. Check all inspection buttons (Enable, Up, Down) and verify that none are stuck in the ON position.
Hoistway Access Enabled
Description: Hoistway access inspection operation which was previously disabled is now enabled.
Hoistway Access Inspection Operation, Hoistway Access Operation, Hoistway Access
Description: Car is on Hoistway access (enabled by the Hoistway access switch).
Car Reaction: If running, car will make an emergency stop and is taken out of normal service. Under this
mode, car can only be moved manually using access key switches.
Troubleshooting:
1. Related inputs: HoistwayAccess: Normally high
Table 6.3 iControl Messages
iControl Messages