Morooka MST-800VD, Руководство по эксплуатации и техническому обслуживанию

Страница: 29 / 134

1-17
7. PRECAUTIONS FOR TRANSPORTATION
USE SAFE RAMPS
Always use ramps which fulfill the following conditions.
• Strong ramps which can fully support the weight of the machine.
• Ramps with a width greater than the width of the crawlers.
• Ramps of a length which will not form a steep angle when placed
against the platform of the truck or trailer to be used for
transportation.
If the ramps are too long and they bend excessively, use blocks to
support the ramps as necessary.
• Ramps with hooks and non-slip surface.
• Be sure that the ramp surface is clean and free of grease, oil, ice
and loose materials. Remove dirt from the machine tracks.
LOADING AND UNLOADING
Loading and unloading the machine always involves potential
hazards. EXTREME CAUTION SHOULD BE USED.
Always do as follows
• Perform loading and unloading on firm level ground only.
• Stop the engine of the haulage truck, apply the parking brake
securely, then block the tires.
• Set the ramps parallel and in line with the width of the crawlers.
• Fix the hooks of the ramps securely to the truck platform.
• Set the machine to be loaded in line with the ramps, then approach
the ramps at low speed.
• Do not correct the direction of travel when on the ramps.
If it is necessary to change the direction, drive the machine off the
ramps, and set the machine to the correct direction.
• After loading, put blocks under the front and rear of the crawlers to
prevent the machine from moving, then tie the machine down with
chains or wire rope.
SHIPPING
• When shipping the machine on a hauling vehicle, obey all state and local laws governing the weight,
width, and length of a load. Also obey all applicable traffic regulations.
• Take into account the width, height and weight of the load when determining the shipping route.