Morooka MST-800VD, Руководство по эксплуатации и техническому обслуживанию

Страница: 72 / 134

2-38
3.6 STEERING MACHINE
• Do not turn the machine sharply at high speed; do not carry spin turns unless necessary.
This will damage the crawler and hydraulic equipment, and there is also danger that the machine may hit other
objects.
• The machine may slip to the side if it is turned on a slope, so avoid turning on slopes as far as possible. Be
particularly careful about turning on soft ground of clay ground.
• When traveling forward downhill, if the angle of the slope goes above a certain range, the SLOPE CAUTION
lamp on the instrument panel lights up and the slope alarm buzzer at the rear of the operator's compartment
sounds to warn the operator.
It is dangerous to turn with the dump body loaded if the slope alarm buzzer sounds.
Dump the load immediately to empty the dump body, then turn slowly.
• If a dangerous state occurs by any possibility, and when it becomes necessary to stop the machine urgently,
press the parking brake switch to set it to the ON (STOP) position or turn the engine starting switch to the OFF
position to stop the engine.
[1] GRADUAL TURN
The radius of the turn is determined by the difference in the amount that the left
and right travel levers are operated. The larger the difference between the left
and right travel levers, the smaller the radius of the turn will be.
[Turning while increasing speed]
• To make a gradual turn when traveling forward, push the travel lever forward
a small amount on the opposite side to the direction of the turn.
To make a rapid turn when traveling forward, push the travel lever forward a
large amount on the opposite side to the direction of the turn.
When turning to the left, push the right travel lever forward.
When turning to the right, push the left travel lever forward.
• To make a gradual turn when traveling in reverse, pull the travel lever back a
small amount on the opposite side to the direction of the turn.
To make a rapid turn when traveling in reverse, pull the travel lever back a
large amount on the opposite side to the direction of the turn.
When turning to the left, pull the right travel lever back.
When turning to the right, pull the left travel lever back.