Morooka MST-800VD, Руководство по эксплуатации и техническому обслуживанию

Страница: 18 / 134

1-6
DO NOT TOUCH HIGH-TEMPERATURE, HIGH-PRESSURE PARTS IMMEDIATELY AFTER
STOPPING ENGINE
Immediately after stopping the engine, many parts are at high
temperature or under high pressure. If parts are removed or touched
carelessly, there is danger of burns or other injury.
For the following parts particularly, always wait for the machine to
cool down before inspecting.
• Radiator and radiator cap
• Hydraulic tank and hydraulic hoses
• Muffler and all parts of engine.
WAIT FOR ENGINE TO COOL BEFORE CHANGING ENGINE OIL
When changing the engine oil, always follow the precautions below.
• Stop the engine and wait for the engine and oil temperature to go
down before changing the oil.
• After adding oil, tighten the cap and drain valve securely and wipe
up any oil that was spilled.
WAIT FOR WATER TEMPERATURE TO GO DOWN BEFORE ADDING COOLANT
Do not add water to the radiator.
Always follow the precautions below.
• Stop the engine and wait for the water temperature to go down.
• Raise the lever attached to the radiator cap to release the internal
pressure before removing the cap.
• After adding water, tighten the cap securely and wipe up any water
that was spilled.
WAIT FOR PRESSURE TO GO DOWN BEFORE ADDING HYDRAULIC OIL
When adding oil to the hydraulic tank or when changing the oil,
always follow the precautions below.
• Lower the dump body and stop the engine.
• Loosen the hydraulic tank cap slowly to release the internal
pressure completely, then remove the cap.
• After adding oil, tighten the cap and drain plug securely and wipe up
any oil that was spilled.