Morooka MST-800VD, Руководство по эксплуатации и техническому обслуживанию

Страница: 127 / 134

3-33
[2] CHANGE ENGINE LUBRICATING OIL, REPLACE ENGINE OIL FILTER
• Stop the engine and wait for the temperature to go down.
• After adding oil, tighten the cap and drain plug securely, then wipe up any spilled oil.
Set a container under the engine to catch the oil.
Prepare a filter wrench.
1. Go under the machine and remove the drain plug (3) from the engine oil
pan and drain the oil.
Set the container under the engine oil pan to catch the oil.
Be careful not to get oil on yourself.
2. Check the drained oil.
If there are large amounts of metal particles or dirt in the drained oil,
please contact your distributor.
3. After completely draining the oil, tighten the drain plug (3).
4. Using the filter wrench, turn the oil filter cartridge (4) at the right side of the
engine oil pan to counterclockwise and remove it.
5. Clean the oil filter mount, coat the packing surface of the new oil filter
cartridge with engine oil, then install it to the mount.
Fill the Engine oil into the new filter cartridge.
When installing a new filter cartridge, always tighten it by hand, and be
careful not to tighten it too much.
For details, see the separate engine operation manual.
6. Open the engine inspection cover.
7. Remove the filler cap (2) and add the specified amount of engine oil.
For details of the oil to use, see “3. USE OF FUEL AND LUBRICANTS
ACCORDING TO AMBIENT TEMPERATURE”.
Engine oil refill amount: 9 liters (2.38 US gal, 1.98 UK gal)
Use a container with an attached hose when filling with oil.
8. Start the engine, run at idling for several minutes, then check that the oil is
within the range between the top and bottom marks on the engine oil level
gauge. For details, see “7.5 CHECK BEFORE STARTING”.
9. Close the engine inspection cover.