Morooka MST-800VD, Руководство по эксплуатации и техническому обслуживанию

Страница: 121 / 134

3-27
[3] CHECK ENGINE LUBRICATING OIL LEVEL, ADD OIL
• CHECKING OIL LEVEL
1. Open the engine inspection cover.
2. Pull out dipstick (1) and wipe the oil off with a cloth.
3. Insert dipstick (1) fully into the gauge guide, then pull it out again.
4. If there is oil on dipstick (1) in the notched area, the oil level is correct.
If the oil does not reach the bottom of the notched area, add engine oil.
• FILLING WITH OIL
1. Remove the cap (2) and add engine oil.
For details of the engine
oil, see “3. USE OF FUEL AND LUBRICANTS
ACCORDING TO AMBIENT TEMPERATURE”.
Use a container with an attached hose when filling with oil.
2. Check the oil level again, and if it is within the specified range, tighten cap (2)
securely.
3. Close the engine inspection cover.
[4] CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL
1. Use level gauge (1) at the side face of the hydraulic tank to check the oil level
and the condition of dirt in the oil.
Inside level gauge (1) is red ball (7). If red ball (7) floats approximately in
the middle of the level gauge, the oil level is normal.
2. If the oil level is low, remove cap (2) of the hydraulic tank and add hydraulic
oil through the oil filler.
For details of the hydraulic oil, see “3. USE OF FUEL AND
LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”.
3. Check the breather hole inside the cap and clean it if it is clogged.
4. After adding oil, tighten cap (2) securely.