Morooka MST-800VD, Руководство по эксплуатации и техническому обслуживанию

Страница: 25 / 134

1-13
AVOID OBSTACLES
Avoid traveling over obstacles or earth embankments as far as
possible. If the machine has to travel over an obstacle, do as follows.
Never travel over large boulders, breakable objects, pieces of
concrete, or other sharp objects.
• Reduce the travel speed and travel carefully.
• Steer the machine so that the center of the rubber crawler passes
directly over the obstacle. Mount the obstacle slowly, and when the
machine goes over the top and starts to tip forward, stop the
machine. Then slowly start the machine again. Never change
direction when doing this.
• Earth embankments may collapse under the weight or vibration of
the machine and cause the machine to slip, so drive the machine
slowly and do not change speed or direction.
Be particularly careful when traveling over freshly dug ditches. They
may collapse.
TRAVELING ON SLOPES
When traveling on hills or slopes, always follow the precautions
below.
•Do not travel at an angle on a hill or slope, or parallel to the slope.
Such action could result in the machine tipping over or slipping.
• When traveling up hills or slopes, always travel directly up the slope.
Set the travel speed to a low range and keep the travel lever close to
the N position (low speed).
• Do not suddenly change speed on the slope. There is danger that
the direction of the machine may suddenly change and the machine
may slip.
• When traveling down slopes, set the travel speed to a low range,
run the engine at low idling, and operate the travel lever to a position
less than 1/2 of the full stroke from the N position.
If the machine travels too fast, there is danger that the engine will
overrun and the machine may slip.
• Do not travel on grass, fallen leaves, wet steel plates, or other
slippery objects.
• If a dangerous state occurs by any possibility, and when it becomes
necessary to stop the machine urgently, press the parking brake
switch to set it to the STOP position or turn the engine starting
switch to the OFF position to stop the engine.
ENSURE GOOD VISIBILITY
When working in dark places or at night, turn on the head lamps.
Turn on the lights in mist, snow, or rain.