Molift Rail System, Проектирование и установка устройства

Страница: 103 / 112

Wall brackets/wall rails on wooden walls
RSS attachments bolts are tightened to 40 Nm and the number of bolts specified
in the assembly instructions have been fitted.
□
Locking nut on Molift special bolt on the rail is tightened to 40 Nm
□
GENERAL FOR THE SYSTEM
Check that there is no swarf or other objects that can block the rail. The trolley/
host is to run smoothly and without any noise through the entire rail system.
□
All rail ends in the system have been fitted with end stops and end covers. The
end stop screw is tightened to 40 Nm and a rubber bumper is installed in the cor -
rect direction if a Molift HiTrac is installed on the system.
□
Performed at least six lifts with load = system SWL at randomly selected points
along the rail. The trolley/lift is run through the entire system with load=SWL and
runs easily and smoothly both along straight sections and bends,
and transition coupling
□
and/or switches
□
□
The rail system is marked with correct SWL.
□
The hoist fitted to the system has the same or lower SWL
□
The hoist is checked against the hoist checklist (refer to the hoist user manual)
□
The system is correctly marked with safety markings, date, and a valid signature
and certificate number by the authorized fitter.
□
NB!
All parts and components which before, during or after fitting are damaged, de
-
formed or are otherwise defective must be replaced or repaired before the system
can be brought into use!
Service and safety checks may only be performed by staff certified by or staff
working on behalf of Molift Group AS.
Comments:
Place and date :
Signature / Stamp :
Rev E 10/2011 Chapter 4 – Mounting of Molift Rail System Page 101 of 100
Checklist for fitting Molift Rail System