Mitsubishi QJ71E71-100 Series, Руководство пользователя

Страница: 65 / 220

3 - 6 3 - 6
MELSEC-Q
3 WHEN COMMUNICATING WITH MELSECNET/H, MELSECNET/10
RELAY
(1) Station No. <-> IP information system (conversion method) (address:
4
H
... b7, b6)
(a) There are four kinds of Station No. <-> IP information methods as shown
below.
(b) Select one of them according to Section 3.3.2 and make sure to set the
values on this screen using the method selected. (The default conversion
method is the Automatic response method.)
Parameter settings requirement
Conversion method Net mask pattern Conversion setting
Automatic response system
IP address computation system
Table exchange system
Use-together system
: Setting required : Setting not required
(2) Net mask pattern (address: 3A9
H
)
(a) Designate the mask value based on the guidelines given below. This pattern
is used in a logical sum with the local station's IP address when calculating
the IP address of the opposite device using the IP address computation
system.
(b) When setting the sub-net mask, designate the target settings of the IP
address class, network address, and sub-net address so that all bits are "1"
in the mask pattern.
The mask pattern is designated with a decimal/hexadecimal value
obtained by dividing the 32-bit mask value into 8-bit segments.
(c) When the sub-net mask is not designated, the mask pattern designation is
not necessary.
When the mask pattern is not designated, the following mask value is
used as the mask pattern according to the local station IP Address class.
Class Mask value used
Class A FF. 00. 00. 00
H
Class B FF. FF. 00. 00
H
Class C FF. FF. FF. 00
H
(3) Conversion setup (conversion information) (address: 229
H
to 3A8
H
)
(a) The conversion setting is required to obtain the IP address from the Network
No. and station number using the table exchange system.
(b) If the local station is an Ethernet module and the next station to which the
communication request /response message is passed to access other
station is also an Ethernet module, designate the Network No., station
number, and IP address of the next station's Ethernet module.
Designate the values set on "Network parameters, Setting the number of
MNET/10H Ethernet cards" screen.
(c) Designate the Network No. in the range of 1 to 239 (1
H
to EF
H
) and the
station number in the range of 1 to 64 (1
H
to 40
H
).