- 30 -
2. To use as a standing work type sewing machine. (Turn the program mode [C] function [PDS] ON.)
The sewing machine can be used as a standing work type sewing machine with the three connections below using the
lever connector. However, take special care to the intrusion of noise, and use the shortest wiring possible.
【
Note: Procedure for changing the lever connector
】
■
Be sure to turn OFF the power switch when connecting or disconnecting the lever connector.
■
Do not connect the lever connector when you set the function [PDS] to ON in the program mode [C]
(Direct call number = "530")
［
Basic procedure
］
(1) Disconnect the lever connector after turning OFF the power switch
(2) Turn ON the power switch and then, set the function [PDS] to ON. The lever connector still disconnects.
(3) Connect the lever connect after turning OFF the power switch.
(4) Turn ON the power switch and confirm the operation.
※
When the error code MA is displayed, press D key and then, it is released.
(1) When operating with an external variable resistor
("XC-G500" Control switch panel [auto] and
AT in [P] mode is OFF)
(2) For operating with a high speed
("XC-G500" Control switch panel [auto] or
AT in [P] mode is ON)
Lever
(white connector)
0V
1
Operation
2
Thread
trimmer
3
Presser foot
lifter
4
Variable speed
command
5
+12V
6
Lever
(white connector)
0V
1
Operation
2
Thread
trimmer
3
Presser foot
lifter
4
Variable speed
command
5
+12V
6
VC
S1
S2
S3
External variable
resistor
10kΩ
S1
S2
S3
Run
(High speed)
