Mitsubishi Electric FR-CC2-N Series, Инструкция по эксплуатации

Страница: 134 / 184

133
5. PARAMETERS
5.9 Parameter copy and parameter verification
1
2
3
4
5
6
7
8
9
10
 Copying parameter settings stored in the operation panel to the
converter unit
Operating procedure
1.
Connect the operation panel to the destination converter unit.
2.
Selecting the parameter setting mode
Press to choose the parameter setting mode. (The parameter number read previously appears.)
3.
Selecting the parameter number
Turn to " " (Parameter copy), and press .
" " appears.
4.
Selecting parameter write
Turn to change the set value to " ", then press .
appears.
5.
Writing to the converter unit
Press to start writing the parameter settings stored in the operation panel to the converter unit. (It takes about
60 seconds to write all the settings. During copying, " " blinks.)
6.
End of copying
" " and " " are displayed alternately after copying ends.
7.
When parameters are written to the destination converter unit, reset the converter unit before operation by, for
example, turning the power supply OFF.
NOTE
• " " appears when a parameter write error occurred. Perform the operation from step 3 again.