Mitsubishi Electric D75D4, Руководство пользователя

Страница: 608 / 896

12 - 84
MELSEC-Q
12 CONTROL SUB FUNCTIONS
[4] Setting method
The following shows the settings to use the "M code output function".
(1) To specify the M code ON signal output timing for each positioning data
Use " Da.27 M code ON signal output timing".
The following shows the settings to use " Da.27 M code ON signal output
timing".
 Set the M code No. in the positioning data " Da.10 M code".

Set the timing to output the M code ON signal [X4, X5, X6, X7] in the
positioning data " Da.27 M code ON signal output timing".
(2) To set the same M code ON signal output timing for all positioning data
Setting " Pr.18 M code ON signal output timing" enables batch
specification of M code ON signal output timing for each positioning data.
Set 0 in " Da.27 M code ON signal output timing" when using " Pr.18 M
code ON signal output timing". When a value other than 0 is set, " Da.27 M
code ON signal output timing" will be valid. (The setting in " Pr.18 M code
ON signal output timing" becomes valid on the rising edge (OFF to ON) of
the PLC READY signal [Y0].)
The following shows the settings to use " Pr.18 M code ON signal output
timing".

Set the M code No. in the positioning data " Da.10 M code".
 Set "0: Use the set value in " Pr.18 M code ON signal output timing"."
(initial value) in the positioning data " Da.27 M code ON signal output
timing".

Set the timing to output the M code ON signal [X4, X5, X6, X7] in the
detailed parameter " Pr.18 M code ON signal output timing".
Setting item
Setting
value
Setting details
Buffer memory address
Axis 1 Axis 2 Axis 3 Axis 4
Pr.18
M code ON signal
output timing
Set the timing to output the M code ON
signal.
0:
WITH mode
1: AFTER mode
27 177 327 477
Da.27
M code ON signal
output timing
Set the M code ON signal output timing for
each positioning data.
0: Use the set value in " Pr.18 M
code ON signal output timing".
1: WITH mode
2: AFTER mode
2003 +
N 1
(b0 to
b1)
8003 +
N 1
(b0 to
b1)
14003
+ N 1
(b0 to
b1)
20003
+ N 1
(b0 to
b1)
1 N indicates the offset address of each positioning data.
N = ((Positioning data No.) - 1) × 10
Refer to Section 5.2 "List of parameters" for the information on detail settings.