Mitsubishi Electric D75D4, Руководство пользователя

Страница: 677 / 896

15 - 11
MELSEC-Q
15 TROUBLESHOOTING
Related buffer memory
address
Set range
(Setting with sequence program)
Remedy
Axis 1 Axis 2 Axis 3 Axis 4
— — — — — —
— — — — — Check that there is no influence from noise.
— — — — —
Review the sequence program which turns ON/OFF
PLC READY signal (Y0).
— — — — —
Check the power, wiring, and connector connection
status of the drive unit.
— — — — —
• Check the power, wiring, and connector connection
status of the drive unit.
• Check the values in Pr.22 Input signal logic
selection.
• When a drive unit without READY signal output is
used, wire the system so that the drive unit READY
signal input of the QD75 is always ON.
— — — — —
• Check that there is no error on the personal computer
side I/F to which a cable is connected.
• Because communication takes a long time between
the personal computer and a CPU module, ensure
high-speed communication by setting the
transmission speed to high at the transfer setup of
GX Configurator-QP or GX Works2, or connecting the
personal computer directly to the communication I/F
of the CPU module.
• Reduce the load of communication by stopping the
access to a CPU module from GX Developer or GX
Works2 (such as monitor function).
— — — — —
After making an axis error reset (refer to [3] in Section
15.2), perform manual control operation (refer to
CHAPTER 11) to move the axis to the other position in
order that the upper limit signal (FLS) will not turn OFF.
— — — — —
• Check the wiring of the upper limit signal (FLS).
• Check if the values in Pr.22 Input signal logic
selection meet the specifications of the limit switch.
• In a system which does not require a hardware stroke
limit (limit switch), wire the system so that the upper
limit signal (FLS) input of the QD75 is always ON.