Mitsubishi Electric D75D4, Руководство пользователя

Страница: 459 / 896

9 - 137
MELSEC-Q
9 MAJOR POSITIONING CONTROL
(2) Positioning control such as loops cannot be executed by conditional JUMP
instructions alone until the conditions have been established.
As the target of the JUMP instruction, specify a positioning data that is
controlled by other than JUMP and NOP instructions.
Positioning data setting example
The following table shows setting examples when "JUMP instruction" is set in
positioning data No. 1 of axis 1.
Setting item Setting example Setting details
Axis
1 Po
sitioning
data
N
o.
1
Da.1 Operation pattern
– Setting not required. (Setting value is ignored.)
Da.2 Control system
JUMP
instruction
Set the JUMP instruction.
Da.3 Acceleration time
No.
– Setting not required. (Setting value is ignored.)
Da.4 Deceleration time
No.
– Setting not required. (Setting value is ignored.)
Da.5 Axis to be
interpolated
– Setting not required. (Setting value is ignored.)
Da.6 Positioning address/
movement amount
– Setting not required. (Setting value is ignored.)
Da.7 Arc address
– Setting not required. (Setting value is ignored.)
Da.8 Command speed
– Setting not required. (Setting value is ignored.)
Da.9 Dwell time
500
Set the positioning data No. 1 to 600 for the JUMP destination. (The
positioning data No. of the JUMP instruction cannot be set. Setting its
own positioning data No. will result in an error "Illegal data No." (error
code: 502).)
Da.10 M code
1
Set the JUMP instruction execution conditions with the condition data
No.
0 : Unconditional JUMP
1 to 10 : Condition data No.
("Simultaneous start" condition data cannot be set.)
Refer to Section 5.3 "List of positioning data" for information on the setting details.