Mindray Accutorr 7, Руководство оператора

Страница: 93 / 200

Accutorr 7 Operator’s Manual 9 - 7
9.7.4 Switching On/Off Measurement on Clock
In auto measuring mode, if the clock is enabled, the NIBP automatic measurement
interval will be synchronized with the real time clock.
For example, if [ Clock ] is set to [ On ], and [ Interval ] is set to [ 20 min ], and then you start
an NIBP auto measurement at 14: 03, the next measurement will be taken at 14: 20, and
the following measurement time will be 14:40, 15:00 and so on.
9.7.5 Configuring a Custom Program
In the [ NIBP Setup ] menu, you can select [ Custom Program>> ] to configure the
duration of automatic measurement cycle, and the time interval between two NIBP
measurements. You can define two programs, respectively program 1 and program 2.
Each program can at most include five cycles: A, B, C, D, and E. In each cycle, the
[
Duration ] and [ Interval ] can be set individually.
You can start the programmed NIBP measurement manually, and then the monitor
automatically performs the measurement based on the cycle and interval you have
defined. To start the sequence measurement, follow this procedure:
1. Select the NIBP parameter window to enter the [ NIBP Setup ] menu.
2. Set [ Interval ] to [ Program 1 ] or [ Program 2 ].
3. Select [ Start NIBP ], or Press the hardkey.
When the programmed NIBP measurement is in use, the NIBP parameter area displays as
follows:
1. Time of last measurement
2. Time remaining to next measurement
3. Program name
4. Cycle name
5. NIBP measurement Interval
9.7.6 Setting NIBP Alarm Properties
Select [ Alarm Setup>> ] from [ NIBP Setup ] menu. You can set the alarm properties for
this parameter in the popup menu.
1 2 3 4 5