MIMAKI JV400-130SUV, Руководство по эксплуатации

Страница: 9 / 194

Safety Precautions
viii
1
2
3
4
5
6
CAUTION
Power supply Handling of the power cable
• Leave the breaker turned ON.
• Do not turn off the main power switch on the
right side of this machine.
•Use a power cable attached to this unit.
•Take care not to damage, break or work on the
power cable. If a heavy matter is placed on the
power cable, heated or drawn, the power cable
can break to cause fire or electric shocks.
•Connect to a socket-outlet with determinate polarity.
•for PLUGGABLE EQUIPMENT, the socket-
outlet shall be installed near the equipment
and shall be easily accessible.
Heater Handling of ink
• Do not spill liquid on the platen as this may
cause failure of the heater or firing.
• Do not touch platen heaters with bare hand
while it is hot; otherwise, you can get burned.
• If you get ink in your eyes, immediately wash
your eyes with a lot of clean water for at least 15
minutes. In doing so, also wash eyes to rinse ink
away completely. Then, consult a doctor as
soon as possible.
• If anyone drinks ink by mistake, keep him or her
quiet and see a doctor immediately. Do not allow
him or her to swallow the vomit. The contact the
emergency number written in MSDS.
• If you inhale a lot of vapor and feel bad,
immediately move to a location of fresh air and
then keep yourself warm and quiet. Then,
consult a doctor as soon as possible.
• When the machine is to be moved, wait until the
heater temperature drops adequately.
As a criterion, wait at least 30 minutes after you
turn off the power to the heater.
Moving the machine must be limited to on the
same floor where there is no steps. When the
machine is to be moved to any place other than
on the same step-free floor, contact your
distributor or a sales office of MIMAKI.
UV light
• There is some leaking of ultraviolet radiation around the UV irradiation device.UV light applied to your skin
might cause inflammation and/or skin cancer.Though weak UV light might cause no inflammation, repeated
exposure to it may lead to chronic disorders.Avoid applying UV light to your skin and eyes.
• Impairment of eyes caused by UV light may be Acute disorders. Pain in eyes, tearing, etc. Chronic disorders Cataract, etc.
When using this device, take protective measures such as gloves, long-sleeve cloth, light-resistant mask, attached light-
resistant glasses, etc.
• Surface of the floor becomes discolored due to UV leaks
from the printer. Cover the floor with cloth or medium for
shielding the light.
Desirable size of cloth or medium:
JV400-130SUV: 2500mm X 600mm
JV400-160SUV: 2800mm X 600mm
Note on maintenance
• When cleaning the ink-station or the heads, make sure to wear the attached goggles and gloves.
• Do not leave the machine for a long time with the cover opened. Ink may be cured due to outside light, and it
may cause discharge defect.
400mm
300mm
Lay a medium
or fabric on the floor.