MIMAKI JV400-130SUV, Руководство по эксплуатации

Страница: 57 / 194

2-27
1
2
Basic Operation
s
4
5
6
Printing Data
Heater cooling down/ heater on standby
When drying feeding has been completed (when it has not been cancelled with the key) and any
operation is not performed, the heater temperature is decreased to 40 degrees C automatically to prevent
waviness of the media due to heat of the heater and the machine waits for a while. (If the heater temperature is
set to 40 degrees C and less, it does not operate.)
If data has been received, or, if you operate with the key, cooling/ standby status is released.
Cutting a media
For a roll media, two ways are available to cut the media after printing is completed, as follows.
1
Press the key.
2
Press the key.
3
Press to specify the cutting position.
4
Press the key.
• The media is cut.
• When the cutting has been completed, the current mode returns to LOCAL.
Screen display during heater cooling down Screen display during heater on standby
• When a media is cut, be careful that the printed side does not touch the floor or the printed side of
other already cut media.
• When using the take-up device, take up a cut medium using the switch of the take-up device.
• During the origin setting with the jog keys, you can also perform media cutting by pressing the
key. ( P.2-13)
HEATER Co o l i n g d own HEATER o n S t a n d b y
MED I A CUT
[ ENT ]
MED I A CUT
CUT POS I T I ON
[

]
CUT POS I T I ON
0 . 0 - - - -
* * CUT T I NG * *
P L EASE WA I T