MIMAKI JV400-130SUV, Руководство по эксплуатации

Страница: 158 / 194

5-16
Message Cause Solution
An error occurred in the main PCB
3.3VB power supply.
• Turn off the power to the machine and
turn it on after a while.
If the same error message appears
again, contact your local distributor to call
for service.
COM driver becomes the high tempera-
ture.
New Print Head was recognized.
The main PCB Q6 is disabled (short
mode).
An error is detected on the waveform
printed on.
An error occurred in the main PCB
V_CORE power supply.
An error occurred in the main PCB
1.5VB power supply.
An error occurred in the main PCB 12V
power supply.
The machine received some data other
than command data.
• Securely connect the interface cable in
position.
• Use an interface cable conforming to the
specifications.
Any parameter outside the range of accept-
able numeric values was received.
USB device initialization failure.
• Turn off the main power to the machine
and turn it on after a while.
If the same error message appears
again, contact your local distributor to call
for service.
Occurrence of a time out error on a
USB device.
An excessive load was applied to the X
motor.
An excessive load was applied to the Y
motor.
An error due to an excessive current of
the X motor was detected.
An error due to an excessive current of
the Y motor was detected.
E R ROR 1 6 e
M a i n P C B V 3 R 3 B
E R ROR 1 5 f
H E A D DR I V E HO T
E R ROR 1 7 1
N EW H E A D CONN E C T
E R ROR 1 7 2
M a i n P C B Q 6 C h e c k K
E R ROR 1 8 6
HD C OV E R F L OW
E R ROR 1 8 6
HD C UND E R F L OW
E R ROR 1 8 7
HD C S L EW R A T E
E R ROR 1 8 8
HD C MEMOR Y
E R ROR 1 8 a
M a i n P C B V _ COR E
E R ROR 1 8 b
M a i n P C B V 1 R 5 B
E R ROR 1 8 c
M a i n P C B V 1 2
E R ROR 2 0 1
COMMA ND
E R ROR 2 0 2
P A R AME T E R
E R ROR 3 0 4
U S B I N I T E R R
E R ROR 3 0 5
U S B T I ME OU T
E R ROR 4 0 1
MO T OR X
E R ROR 4 0 2
MO T OR Y
E R ROR 4 0 3
X CURR E N T
E R ROR 4 0 4
Y CURR E N T