MIMAKI JV400-130SUV, Руководство по эксплуатации

Страница: 40 / 194

2-10
10
Pull out the roll media out.
(1) Open the front cover and the shading cover.
(2) Raise the clamp lever from the back of this machine.
(3) Pull out the roll media gently and then stop pulling when
locked lightly.
11
Make the roll media even then lower the clamp
lever.
• Pulling several positions of the media lightly, Lower the
clamp lever after confirming that the amount of the roll
media pulled out is almost even.
12
Hold the media with the media press gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• When using a thick media, remove the media press from
the media before printing.
• When setting a medium, be sure to cover
the medium sensors located on the rear of
the platen. The media cannot be detected
unless it is placed over the sensor.
• In case that you use 240mm-wide media, media cannot be detected if it is set in
accordance with . Set media approximately 30mm inner than .
•
Do not set the media outside
. As media may tilt and be lifted, it could break the
head.
• If a media is misaligned to the right more than fixed
position, a warning is displayed. Set the media
again.
Media press
Do not set outside
this mark.
Media
Media Press
E R ROR 5 1 6
ME D I A S E T P O S I T I ON R