Mikrotron eosens TS3, Руководство пользователя, Страница: 38 / 120

11S-3000M
page 29
Trigger
Press the Trigger bu tt on, (see “TS3 Top View” on page 4) or send an electrical trigger signal
(see “Appendix D: Power and I/O Connections ).
When triggered, the TS3 will capture frame “0” and the post-trigger frames. The progress bar will
change color and move from the trigger point to the end as in the three images below. When the
recording is complete, the progress bar will turn solid green.
The TS3 will now either enter Review Mode or, if Autosave has been enabled, the camera will save
the images to a mass storage device and go back to Armed Mode, capturing pre-trigger frames and
watching for a Trigger.
4-8 Autosave
The TS3 may be used to capture many consecuti v e events. Using Autosave, this can be done una tt ended,
that is, the camera may be left at a location t o automati c ally, Trigger, Save captured imagery, and then
re-Arm itself indefini t ely-constrained only by the mass storage space available.
Consider that a TS3 with an optional 256GB SSD in s talled, depending on the resolution and
d o wnload file f ormat, could record and save hundreds or even thousands of events in a completely
una tt ended mode! Even if using an SDHC, many events may be captured.
Advantages of using Autosave:
• Autosave is the only choice for
multiple unattended events . For remote locations or
lo c ation where networking is not possible, or for long shifts whe r e there may be multiple
e vents of interest that need to be captured without human intervention .
• Autosave is also useful for production environments or in any scenario where it is used for
multiple c onsecuti v e tests without any setup changes. Here it is preferred because it limits human
intervention, the r eby limiting both human eff ort and the possibility of human error.
• In an unattended event, especially in a remote location or when there is no easy access to the
camera, Autosave is recommended because it is the quickest way to secure the image data.
Saving the data to nonvolatile memo r y can be important if there is a possibility of power loss.
-2449
-09.796
[CAP] ROI:1280x 1024 FPS:250 EXP: 8X (0.500 ms) TrigPos: 50%
T
+2449
+09.796
Batt: 53%
-2449
-09.796
[CAP] ROI:1280x 1024 FPS:250 EXP: 8X (0.500 ms) TrigPos: 50%
T
+2449
+09.796
Batt: 53%
-2449
-09.796
T
+2449
+09.796
Figure 4-10: Recording Progress: Triggered TS3
-2449
-09.796
[REVIEW] ROI:1280x 1024 FPS:250 EXP: 8X (0.500 ms) TrigPos: 50%
T
+2449
+09.796
Batt: 53%
T3 User Manual