Mikrotron eosens TS3, Руководство пользователя, Страница: 16 / 120

11S-3000M
page 7
2 TS3 Getting Started
2-1 Unpacking the Camera
Part
STD OPT Part #
TS3 Camera X TS3100XXX
C-Mount (factory installed and adjusted on the camera) X
F-Mount (factory installed and adjusted on the camera) X 1105-0200
DC Power Supply-- 110/220VAC, 50/60Hz, 12V @ 4.17A, with IEC 13 socket and 5-pin
LEMO connector (no power cord included)
X 1105-0250
8 GB SDHC Card X 1105-0270
16 GB SDHC Card X 1105-0271
32 GB SDHC Card X 1105-0272
I/O Cable--1.3 meter with 8-pin LEMO camera connector and BNC connectors for Sync-In,
Sync-Out, and Trigger-In
X 1105-0401
Wireless Dongle X 1105-0275
Documentation and So ftw are (on thumb drive) X
Ba tt ery--Rechargeable Li-Ion 3.7V 15,600mAh (Ba tt ery comes fully charged from factory) X 1105-0050
Hoodman 7” LCD Display Cover for glare protectio X 1105-0330
MIKROTRON retails its cameras through independent distributors. MIKROTRON or its distributors
can provide the accessory items required for camera operation according to each customer’s
particular application needs.
2-2 Installing the Lens
The camera is shipped with a C-mount lens adaptor installed and adjusted at the factory. To install a
C-mount lens, follow these steps:
1. Select a C-mount lens for use with the camera.
NOTE: There are many C-mount lens formats and focal lengths available. The 22.9mm diagonal sensor
of the TS3100L is larger than the light circle produced by many C-mount lenses. This is especially true
for wide angle lenses, but it is dependent on lens design and format. Vignetting (da
rk ening at the
edges of the image), will occur when the image on the sensor, the size and location of which is
dependent on resolution and ima g e t o set, is not covered by the image circle of the lens. (See “Table
2-2: Lens Selection .)
2. Remove the lens receptacle cover from the camera’s C-mount. This is a cover that is installed
at the factory to protect the camera optics and sensor f r om dust contamination
NOTE: Whenever threading lenses on or off the c amera, face the camera lens down so that
any contamination on the th r eads will tend to fall away from the camera rather than into it.
3. Thread the C-mount lens into the lens mount located in the front of the camera. DO NOT
overtig h ten the lens! The lens should be “fin g er tig h t” only--just tig h t enough that you can adjust
focus and aperture without unscrewing the lens.
NOTE: Limit the time b e tween removal of the receptacle cover and installation of the lens. Du s t
could settle on the f ace of the sensor cover glass and degrade the image quality.
Table 2-1: Package Contents:
T3 User Manual