61
The Administrator can specify alarm actions that will take when tampering is
detected. All options are listed as follows:
Enable Alarm Output
Check the item and select the predefined type of alarm output to
enable alarm relay output when
tampering
is detected.
Record Video Clip
Check the item and select a video recording storage type, <SD
Card> or <NAS> (Network-Attached Storage). The alarm-triggered
recording will be saved into the microSD card.
Pre-trigger buffer recording function allows users to check what
happened to cause the trigger. The pre-trigger buffer time range is
from 1 sec. to 3 sec. Select <Upload for
sec> to set the
recording duration after alarm is triggered. The setting range is
from 1 sec. to 99999 sec. Select <Upload during the trigger active>
to record the triggered video until the trigger is off.
NOTE:
Please make sure the local recording (with microSD
/ SDHC card) or the remote recording (with NAS) is
activated so that this function can be implemented. Refer to
section
Recording
for further details.
Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by
FTP and/or E-Mail when tampering is detected.
Upload Image by FTP
Select this item and the administrator can assign a FTP site and
configure various parameters. When tampering is detected, event
images will be uploaded to the appointed FTP site.
<Pre-trigger buffer> function allows users to check what happened
to cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined. On the other hand, <Post-trigger buffer> is for users
to upload certain amount of images after tampering is triggered.
NOTE:
Normally the setting range of the <Pre-trigger buffer>
is 1 to 20. However, the setting range will change accordingly
if the frame rate of MJPEG on the <Video Frame Rate>
setting page is 6 or smaller.
Check the box <Continue image upload> to upload the triggered
images during certain time or keep uploading until the trigger is off.
Select <Upload for __ sec> and enter the duration in the blank. The
images of the duration will be uploaded to FTP when tampering is
triggered. The setting range is from 1 to 9999 seconds. Select
<Upload during the trigger active> to make the images keep being
Содержание SP5563A
