57
NOTE:
Normally the setting range of the <Pre-trigger buffer>
is 1 to 20. However, the setting range will change accordingly
if the frame rate of MJPEG on the <Video Frame Rate>
setting page is 6 or smaller.
Check the box <Continue image upload> to upload the triggered
images during certain time or keep uploading until the trigger is off.
Select <Upload for __ sec> and enter the duration in the blank. The
images of the duration will be uploaded to FTP when the motion
event occurs. The setting range is from 1 to 9999 seconds. Select
<Upload during the trigger active> to make the images keep being
uploaded to FTP during the trigger active until the event stops. Set
the Image frequency as the upload frame rate. The setting range is
from 1 frame to 15 frames.
NOTE:
Make sure FTP configuration has been completed.
Refer to
FTP
for further details.
Upload Image by E-Mail
Select this item and the administrator can assign an E-mail address and
configure various parameters. When motion is detected, event images
will be sent to the appointed E-mail address.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger
buffer> frame rate could be
pre-determined. On the other hand, <Post-trigger buffer> is for users to
upload certain amount of images after the motion event occurs.
NOTE:
Normally the setting range of the <Pre-trigger
buffer> is 1 to 20. However, the setting range will change
accordingly if the frame rate of MJPEG on the <Video Frame
Rate> setting page is 6 or smaller.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload
for
sec> and enter the duration in the blank. The images of
the duration will be uploading by E-mail when the motion event occurs.
The setting range is from 1 sec. to 9999 sec. Select <Upload during the
trigger active> to make the images keep being uploaded to E-mail during
the trigger active until the event stops. Set the Image frequency as the
upload frame rate. The setting range is from 1 frame to 15 frames.
NOTE:
Make sure SMTP configuration has been completed.
Содержание SP5563A
