MICRO-EPSILON reflectCONTROL RCS, Инструкция по эксплуатации

Страница: 66 / 134

Description of the “Data Preprocessing” View
Page 66
Display Elements and Parameters in the “Plane Alignment” Program:
A “General” toolbar: Using this toolbar, you can select the data source (see Chapter 3.4 und 3.5 ),
save and load parameters and reset selected parameters to default settings (see Chapter 3.17 ).
B List of active measuring programs: This section displays the active measuring programs from the
“Data preprocessing” group. You can add and remove measuring programs (see Chap.
3.13 ),
move them (see Chap. 3.14 ) and select an active measuring program for parameterizing and dis-
playing the measured values.
C Measuring program groups / Tab bar for switching between views: This tab bar allows you to
switch between the four main views (see Chap.
3.2 ). To the left of the tab bar you find the section
for adding, removing and selecting measuring program groups (see Chap. 3.15 ).
D 3D-View: The 3D-View visualizes the 3D data (see Chap. 3.10 ).
E 3D-View toolbar: Use this toolbar to configure the orientation of the coordinate system in the 3D-
View (see Chap.
3.10 ).
F “Start measurement” button: Click on this button to perform a measuring operation, calculate the
measurement results and display the point cloud and measurement results of the currently se-
lected measuring program in the 3D-View.
G Status bar: Status and error messages are displayed in the status bar (see Chapter 8.1 ).
1 Input data: Use this selection field to select the input data, the reference plane and the rotation
point for the program (see also Chap.
3.16.3 ). Different objects can be used for each individual in-
put type:
-
Point:

Point: The selected point is used as rotation point. The following measuring programs
produce points:

“Center of Gravity” measuring program (see Chap. 6.1.1 )

“Extreme Point” measuring program (see Chap. 6.1.2 )
 “Plane Fit” measuring program (see Chap. 6.1.3 )

“Object Intersection” measuring program (see Chap. 6.2.3 )

“Perpendicular Point” measuring program (see Chap. 6.2.4 )
 Sphere: The center point of the sphere is used for the distance calculation. The following
measuring program produces a sphere:

“Sphere Fit” measuring program (see Chap. 6.1.4 )
 Circle: The center point of the circle is used for the distance calculation. The following
measuring program produces a circle:

“Circular Hole” measuring program (see Chap. 6.1.6 )
 “Circular Pad” measuring program (see Chap. 6.1.7 )
-
Plane:

Plane: The selected plane is used as reference plane. The following measuring program
produces a plane:
 “Plane Fit” measuring program (see Chap. 6.1.3 )
-
Display: Select wether input data, output data or both is displayed in the 3D-View.
2 Translate point cloud: You may activate the position correction of the object in addition to the
pitch correction here.
3 3D-View: The 3D-View shows the input point cloud (gray), the reference plane (yellow), the rotation
point (orange) and the aligned point cloud (green).