MFJ MFJ-1270C, Системное руководство

Страница: 229 / 264

MFJ-1270C/1274C MANUAL TROUBLESHOOTING
Page 220
U21 pin 36, and the INT line on pin 16. Each of these lines should show
activity, and if any line is quiet this is a sign of trouble.
Logic lines that show no activity may often be traced to a short on the pc board,
probably due to a solder splash or bridge.
Address and data line shorts may also show up as lack of activity on the control
bus lines, especially the chip selects. Check each of the 16 address and 8 data
lines for activity. Any lines showing a lack of activity are not operating
properly.
If you suspect problems with address or data lines, try removing all the memory
chips. Each address and data line will now show a distinct pattern. The address
lines should be (possibly distorted) square waves whose periods increase by a
factor of two on successive lines as you step line by line from A0 to A15.
If you decide to use an ohmmeter to check for shorted lines, use a low
voltage/low current test instrument. (Most Modern DVMs are fine for this.) If
in doubt, remove any ICs connected to the lines you are measuring. If you
suspect a short, check the high density areas of the PC board for the problem. In
most cases the short will be found there. It is very unlikely that the PC board
itself will have a short.
Symptom: Modem won't calibrate or key transmitter.
Troubleshooting improper calibration amounts to checking for proper signals at
U21 and following up any improper signal. If the calibration signal is present,
but you cannot successfully calibrate the frequency, you may have an out-of-
spec frequency determining component. Check the values of the appropriate
passive components. Also, check the placement of jumpers! As a last resort,
check the signal frequency with a frequency counter. Note that, due to frequency
jitter while calibrating the demodulator, the STA and CON LEDs may blink
somewhat even when the 1700 Hz demodulator frequency is correct.
Calibration of the demodulator and the modulator tones are discuss in the
Appendix chapter.
If the transmitter doesn't key, the problem may be in the watchdog timer, U7, or
the PTT transistors, Q10 or . Check especially for an open timing capacitor C31
or a bad solder connection associated with R83.
Symptom: Uncopyable transmitted or received packets