MFJ MFJ-1270C, Системное руководство

Страница: 140 / 264

MFJ-1270C/1274C MANUAL COMMANDS
Page 131
cmd:
CONVERS
Hello World! I'm on the air on packet radio!
[enter <CTRL-C>]
cmd:
See the entry under
CMDTIME or the discussion of Transparent Mode in Chapter
5 for information on how the Command Mode entry character is used for escape
from Transparent Mode.
For terminals without a "control" key, you will have to reasign another key such as
a graphic symbol or punctuation mark which is normally not used in operations.
CONM ODE C ONVERS T RANS Mode: Packet Default: CONVERS
Parameters:
CONVERS Sets automatic entry to Converse Mode when a
connection is established.
TRANS Sets automatic entry to Transparent Mode when a
connection is established.
CONMODE controls which mode the MFJ TNC will be placed in after a
connection is established. The connection may result either from a connect
request received over the air or a connect initiated by a
CONNECT command that
you issued. For most operations, you would set CONMODE to CONVERS .
However, if you are using Transparent Mode for a bulletin board program, for
example, you would set
CONMODE to TRANS so that the correct mode will be
entered when your bulletin board receives a connect request.
If you initiate a connection with the
CONNECT command, the control of
Converse or Transparent Mode is determined by NEWMODE .
If the MFJ TNC is already in Converse or Transparent Mode when the connection
is completed, the mode will not be changed. If you have typed part of a command
line when the connection is completed, the mode change will not take place until
you complete the command or cancel the line. This prevents the last part of your
command from inadvertently being sent as a packet.