MFJ MFJ-1270C, Системное руководство

Страница: 209 / 264

MFJ-1270C/1274C MANUAL MESSAGES
Page 200
Link Status Messages
These messages inform you of the status of AX.25 connections your MFJ TNC
may be involved in. You can always interrogate the link status by giving the
CONNECT command without parameters. If you attempt a connection when
your MFJ TNC is not in the disconnected state, the MFJ TNC will display the
link status but will take no other action. The following messages appear in
response to the
CONNECT command.
Link state is: CONNECTED to call1
IA
call2[,call3...,call9]]
This display shows the station your MFJ TNC is connected to and the
digipeater route if any. The
callsign sequence is the same sequence you would
enter to initiate the connection.
Link state is: DISCONNECTED
No connection currently exists. You may issue the
CONNECT command to
initiate a connection.
Link state is: CONNECT in progress
You have issued a connect request, but the acknowledgment from the other
station has not been received. If you issue a
DISCONNE command, the connect
process will be aborted.
Link state is: DISCONNECT in progress
You have issued a disconnect request, but the acknowledgment from the other
station has not been received. If you issue a second
DISCONNE command, the
MFJ TNC will go immediately to the disconnected state.
Link state is: FRMR in progress
The MFJ TNC is connected but a protocol error has occurred. This should
never happen when two TAPR TNCs are connected. An
improperimplementation of the AX.25 protocol could cause this state to be