MFJ MFJ-1270C, Системное руководство

Страница: 188 / 264

MFJ-1270C/1274C MANUAL COMMANDS
Page 179
RVf ALWAY ON|OFF Mode: Mailbox Default: ON
Parameters:
ON Initiates forwards and reverse forwards of all forwardable
messages.
OFF Mailbox ignores Forward and NODEforw commands.
The setting of
RVFALWAY (s) controls whether the TNC will initiate forward
events ( FORWARD , NODEFORW ) in the absence of forwardable messages. If
OFF, the TNC will ignore FORWARD and NODEFORW commands entered in
the absence of forwardable messages. When ON, the TNC runs the event for the
sole purpose of eliciting reverse-forwardable messages from the remote BBS.
S CREENLN n Mode: All Default: 0
Parameters:
n 0 - 255, Specifying the screen or platen width, in characters, of
the terminal.
This value is used to properly format terminal output. A <CR> <LF> sequence is
sent to the terminal at the end of a line in Command and Converse Modes when n
characters have been printed. A value of zero inhibits this action.
If your computer automatically formats output lines, you should set
SCREENLN
0 to avoid a conflict between the two line formats.
SE NDPAC n Mode: Packet Default: $0D <CR>
Parameters:
n 0 - $7F, Specifying an ASCII character code.
This command selects the character that will force a packet to be sent in Converse
Mode. The parameter
n is the ASCII code for the character you want to type in
order to force your input to be packetized and queued for transmission. You can
enter the code in either hex or decimal.