Metcal RSS-1000-CVSI, Руководство пользователя

Страница: 84 / 396

USER MANUAL, RSS-1000-CVSI
7000-5970
Rev.
A
page
84
of
396
SAFETY COVER INSTALLATION & ACTIVATION
Metcal™ offers the 1000 Safety Cover accessory or AC-RSS-1KSC as a means of both
protecting operators from accidents and protecting the Robotic Soldering System from environmental
obstructions. The AC-RSS-1KSC encloses the Robotic Soldering System in acrylic, allowing for
maximum visibility of the unit at all times while preventing unintended access. The front of the system
is open for operator access to the unit but is protected with a light curtain. This curtain emits an
infrared light beam across the opening that is always active. When this beam is broken, all motion
will be stopped immediately. This would be similar to the behavior of activating the emergency-stop
button. The system will remain in this suspended mode until the beam is no longer broken and the
emergency-stop pop-up message is cleared.
In addition, the bottom of the rear panel is open for cable routing access. Lastly, there is an
access hole on the right-hand side of the unit for emptying the solder cleaner tray and an access door
for tending to the solder feeder. The door comes with a locking mechanism to further prevent
unintended access to the solder feeder and spool to prevent theft or injury.
When equipped, the following will describe the components of the Safety Cover, as well as
procedures on how to install and activate the Safety Cover after installation.