Metcal RSS-1000-CVSI, Руководство пользователя

Страница: 350 / 396

USER MANUAL, RSS-1000-CVSI
7000-5970
Rev.
A
page
350
of
396
8. Tap the green box to the right of X - Value
9. Tap the backspace key on the numeric keypad.
10. Enter a value that will fall into range based off the programmed Tip Cleaning Profile Start
Location.
10.1. In this example, two points were identified as out of bounds, one located at 400.007, 0, 50, 0
(X, Y, Z, Θ) and the other was located at 405.002, 0, 50, 0. Because the value programmed
within the profile was 390.007, this would imply that the Tip Cleaning Profile Start Location
was programmed at 390mm in the X-Axis. (This is because the programmed point is at
390.007 in the X-Axis but identified as out of bounds at 400.007. There is a 10mm shift to the
right in the X-Axis. A shift can only occur if the TCP Start Location is programmed in a
location differing from the start location of the TCP. In this case, it was programmed at
390mm.)
10.2. Using this example, the proper choice would be any value >10mm to the left but not a value
so great that it no longer falls within the cleaning zone. Therefore, a value of 10.5 will be
chosen, which in turn makes the X-Value coordinate 379.5.