Metcal RSS-1000-CVSI, Руководство пользователя

Страница: 345 / 396

USER MANUAL, RSS-1000-CVSI
7000-5970
Rev.
A
page
345
of
396
7. Tap on the yellow box to the right of the Solder Point Clean Frequency icon to enter the
number of joints the unit will solder before heading to the cleaning zone.
8. Tap on the yellow box to the right of the Solder Point Clean Frequency icon to enter the
number of joints the unit will solder before heading to the cleaning zone.
9. Tap on the yellow box to the left of the Solder Retract Length icon to enter the length (in
millimeters) of solder that is to be retracted into the solder tube assembly during the cleaning zone
9.1. This information will only be known once the solder feeder tube assembly is adjusted in the
desired location.
9.2. With the iron hot, solder should be fed until the solder wire contacts the tip.
9.3. After contact is made, use a pair of calipers to measure the length from the solder feeder tube
to the tip of the un-melted solder wire.
9.4. Enter measured value in the yellow box to the left of the of the Solder Retract Length icon.
10. Tap the Confirmation button to accept all settings and proceed with the implementation of
the Tip Cleaning Profile.
10.1. Tap the Cancel button to make any further changes or to abort any changes
altogether.
Tip Cleaning Profile Implemented!