Metasys IFC-1010, Раздел программирования технического руководства

Страница: 51 / 104

Programming—IFC-1010/2020 Programming 51
5 = AMAP
Map to an
annunciator?
Enter annunciator
number.
Enter software zone,
addressable device, or
annunciator point.
(Address Prompt)
No No
Change
annunciator
mapping?
anmapfc.cdr
Yes
Yes
Figure 41: Flowchart for the Annunciator Mapping Option
The following CRT display illustrates Mapping Monitor Module 11 on
SLC 1 to Annunciator Module 1, Point 1.
PRESS 1=TYPID,2=CBE,3=LBL,4=OPTNS,5=AMAP,6=CCBE : 5
ENTER LXX(D/M)YY, ZXXX OR AXXPYY FOR PT. CHANGE (BCKSPC TO ABORT) : L1M11
DO YOU WANT TO CHANGE THE ANNUNCIATOR MAPPING FOR THIS POINT? (Y=YES,N=NO) : Y
DO YOU WANT THIS POINT MAPPED TO AN ANNUNCIATOR? (Y=YES,N=NO) : Y
ENTER AXXPYY FOR ANNUNCIATOR POINT MAPPING : A1P1
If an annunciator point has more than one control point mapped to it, then
all the control points must have identical CBE and signal silence
programming. Each telephone point must have its own distinct
annunciator point for telephone ring signal to function. Each annunciator
point must be installed through Full Point Programming before a device,
module, or software zone may be mapped to it.
Notes: Each detector, module, or zone may be mapped only to
one annunciator point. Therefore, if it is desired to map a detector,
module or zone to more than one annunciator point, the detector,
module, or zone may be mapped to a dummy zone and the dummy
zone may be mapped to an annunciator point (see Figure 42). This
is for annunciation purposes only.
Use custom shadow annunciator
software if control is desired from both annunciators. Contact Field
Support Services in Milwaukee for further information.
For annunciator point mapping information on an IFC-1010/2020
with the Metasys Fire Network, refer to the
Operation section of
the Installing the Fire Fighters Command Center Technical
Bulletin (LIT-448165) in the IFC-1010/2020 Technical Manual .