Medica EasyStat, Руководство оператора

Страница: 41 / 158

35
o p e r a t i n g t h e a n a l y z e r
r
s
s
s
Quality Control Analysis
Follow the manufacturer’s storage and handling instructions for quality
control material before proceeding with quality control analysis.
The Easy QC materials are aqueous solutions with gasses dissolved in
them along with other components necessary to qualify the electrodes.
Prior to the testing of these materials, careful attention needs to be
paid to the instructions. If the ampules are not prepared and handles
as instructed, erroneous readings may result.
Refer to the insert sheet enclosed in the Easy QC package for proper
handling instructions.
The sampler must be in the syringe mode position.
Select
ANALYZE QC
for Level 1, 2, 3 or Hct. Select the desired
level. Break open the quality control ampule and analyze immediately .
Lift the sampler and
PROBE IN CONTROL?
is displayed.
Place the probe in the quality control material and press YES. Hold
the ampule in place, keeping the probe submerged in the ampule until
REMOVE CONTROL RETURN SAMPLER
is displayed.
Push the sampler down into the closed position. The quality control is
analyzed and results for each parameter are displayed and printed.
Results falling outside the quality control limits are flagged as ( ↓ ) low
or ( ↑ ) high.
Three quality control results for each level are automatically stored
each day when no errors are detected. When more than three of a
control level are performed on the same day, the three most recent
results replace the results previously stored for that day. The EasyStat
analyzer stores up to 93 quality control results for each level.
If a result is outside the limits or an error occurs, a
STORE
RESULTS?
prompt is displayed. Press YES to store quality control
results, or NO to reject the results.
If selected, quality control correlation factors will be applied to results.