Mec Speed Level 2684 ES, Руководство по обслуживанию и запасным частям

Страница: 91 / 206

“3084 Speed Level™ Sigma Lift” Service and Parts Manual November 2009
Page 3-7
M
E C H A N I C A L
C
O M P O N E N T S
F
L O A T I N G
A
X L E
L
O C K
C
Y L I N D E R S
There are two Floating Axle Lock Cylinders located at the front of the machine.
R
EMOVE
1. Raise and support the front end of machine.
2. Disconnect hydraulic hoses. Immediately cap and plug all openings to prevent con-
tamination.
3. Remove the bolt and banjo pin that secures the pivot pin to the frame and remove the
pivot pin.
4. Remove the bolt and banjo pin that secures the pivot pin to the floating axle and
remove the pivot pin.
R
EPLACE
Installation is reverse of removal. Apply one (1) drop of Loctite® to the bolts that secure
clevis pins.
B
LEED
P
ROCEDURE
- 3084RT
Use this procedure for machine model 3084RT.
1. Start engine.
2. Loosen the bleed valve located on the top of the cylinder.
3. Watch as air escapes from valve.
4. Once a steady stream of fluid runs from the valve, tighten the valve.
5. Repeat on opposite side.
B
LEED
P
ROCEDURE
- 3084ES
Use this procedure for machine model 3084ES.
1. Loosen the bleed valve located on top of the cylinder
2. Drive the machine very slowly while watching as air escapes from the valve.
3. Once a steady stream of fluid runs from the valve, tighten the valve.
4. Repeat on opposite side.