Mec Speed Level 2684 ES, Руководство по обслуживанию и запасным частям

Страница: 129 / 206

“3084 Speed Level™ Sigma Lift” Service and Parts Manual November 2009
Page 4a-25
T
R O U B L E S H O O T I N G
- 3 0 8 4 R T
M O D E L S
- - E
Z
- C
A L
R
E T R I E V E
M
O D E
A
N D
H
E L P
M
E S S A G E S
RELEASE TRIGGER! ____________________________________ Flash Code: 2/2
• The trigger was closed at power-on, or closed for too long with no function selected.
RELEASE GROUND SWITCHES!___________________________ Flash Code: 2/2
• Ground function switches were closed at power-on.
RELEASE JOYSTICK SWITCHES! __________________________ Flash Code: 2/2
• Platform joystick switches were closed at power-on, or closed for too long without trigger
switch (see SETUPS/INTERLOCKS/TRIGGERwait ).
RELEASE OUTRIGGER SWITCHES! ________________________ Flash Code: 2/2
• Outrigger switches were closed at power-on.
W I R I N G M
E S S A G E S
The following are “wiring” HELP messages – problems have been detected which are
likely due to vehicle wiring issues:
FAULT: ENERGIZED VALVE - CHECK P5 WIRING! ____________ Flash Code: 3/2
FAULT: VALVE FEEDBACK HIGH - CHECK VALVE WIRING! _____ Flash Code: 3/2
• There is a voltage on one or more valve outputs, when all outputs are off.
• Check each valve output to trace where the invalid supply is coming from.
FAULT: CAPBANK VOLTAGE TOO HIGH - CHECK LINE CONT! __ Flash Code: 3/3
• The voltage on the B+ stud of the controller (connected to an internal voltage stabilization
capacitor bank) is too high when the line contactor is off. B+ stud voltage should be approxi-
mately 32 volts at idle.
• Check the line contactor tips are not welded, and check the power wiring for errors .
FAULT: ENERGIZED LINE CONTACTOR - CHECK P5 WIRING! __ Flash Code: 3/4
• There is a voltage on the line contactor coil output, when it is off.
• Check wiring to the line contactor coil to trace where the invalid supply is coming from.
FAULT: MOTOR OVERLOAD! ______________________________ Flash Code: 3/5
• The power protection circuits in the controller have activated to protect from extreme over-
load.
• Check for short-circuit power wiring; check for a seized or shorted motor.